Ram no-drill, Seat bases – RAM Mount RAM-VB-177-SW1 User Manual
Page 2

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the two front seat rail bolts. These are found
holding the front of the passenger side seat frame legs to the floor board. Do not discard these bolts. Save them for
use should you later remove this product from the vehicle.
2. Should you choose to use the optional riser, attach it to the No-Drill™ base now.
3. Take the longer seat leg bolts provided and pass each through the flat washer. Next, pass the bolt through the slots
of the No-Drill™ base.
4. Place the stand offs over the holes where the factory seat leg bolts were previously.
5. Lower the No Drill base down over the stand offs, pass the bolts through the stand offs, and into the threaded holes in
the floor board. Start the thread by hand.
Once both bolts have been started by hand, use a wrench to fully tighten these bolts and secure the base until rigid.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-177
DODGE AVENGER (2007-2010)
DODGE CALIBER (2007-2009)