RAM Mount RAM-VB-164-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Tools suggested for this installation are ½” box end wrench or socket wrench.
1. Detach the seat frame skirt from the front and left side of the passenger seat.
2. Locate the two bolts that pass through the “u” shaped seat track into the frame at the front and back.
3. Using a ½” wrench, remove the nut that holds the seat track to the upper part of the seat frame. Set the nuts
aside. HINT: Using a small screw driver to wedge the bolt inside the seat track may keep it from falling out of place
during installation.
4. Carefully raise the seat up so that the seat track is above the seat frame with the two track bolts hanging down.
You only need to raise the seat enough to pass the no drill base in between.
5. Place the No-Drill
TM
base in between the seat track and seat frame with the mounting holes aligned with the
two bolts hanging down.
6. Slowly lower the seat so that the bolts pass through the holes in both the No-Drill
TM
base and the seat frame.
7. Re-install the nuts previously removed and tighten.
8. Using the provided nut and bolt, further secure the No-Drill
TM
base by passing the bolt though the hole on the
vertical surface of the no drill base. This is located near the center of the base and aligns with a hole in the factory seat
frame. Tighten the nut.
9. Re-install the seat frame skirt.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-164
SEARS SEATING ATLAS SERIES SEATS (2005-NEWER)