RAM Mount RAM-VB-172-SW1 User Manual
Ram no-drill, Seat bases, Vehicle base for the
Installs in minutes with no drilling required.
Lifetime warranty!
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side, in front, where seat frame meets
floor board.
Drilling Required
None - uses existing seat bolts
Seat Configuration
Bucket
Pole or Pedestal
Ordered Separately
Weight
6.1 lbs
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 18.23", B = 7", C = 1.95",
Hole Center = 16.31"
Features
Complete Vehicle Mount
RAM-VB-172-SW1
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-172 & RAM-VB-172-SW1
FORD EDGE (2007-2013)
FORD FUSION (2013)
A
B
C
Vehicle Base
RAM-VB-172
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Vehicle base for the
INSTALLATION INSTRUCTIONS
Depending on your make and model, there may be pieces of plastic trim that cover the lower front of the seat frame
legs. This will need to be removed and stored. If you wish to reinstall this piece of trim, you will have to modify it to fit
over the stamped metal base.
1.
Move the passenger side seat to its rearmost position. Using socket wrench, loosen and remove the two
bolts holding the seat frame legs to the floor board.
2.
Place the No-Drill™ base over the seat frame legs with the pedestal platform near the center of the vehicle.
Note that for the Ford Fusion, the base will install under the seat frame legs, not over them.
3.
Re-install the two seat frame bolts. Start the thread by hand and then fully tighten with the 18MM wrench.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-172 & RAM-VB-172-SW1
FORD EDGE (2007-2013)
FORD FUSION (2013)
The photo below depicts the install into a Ford Fusion. The arrows show areas where the fit is tight. This base does
touch the carpeting of the center hump. It will also touch and flex slightly the plastic seat leg covers. This does not
affect the functionality or appearance of the seat leg covers.