RAM Mount Tough Dock for Getac B300 - Manual (Page 2)

(Continued)
National Products, Inc., 8410 Dallas Ave South, Seattle, WA 98108, (206) 763-8361 www.rammount.com
Troubleshooting:
Problem:
Power In/Out LED's will not light and/or laptop will not charge.
Solution:
1.
Switch power switch to ON position.
2. Make sure fuse is intact and properly seated.
3. Make sure power cable is firmly attached to power jack
and external 12-28vdc.
4. Remove fuse, and with voltmeter check voltage across fuse terminals. If polarity is reversed
Check all connections; reverse power cable if necessary.
Ground
+12-28V
Power cable:
Black wire: Ground
White wire: 12-28vdc Power Jack
+12-28V
Ground
RF Jack: Co-axial
RMR-INS-234-GET2_rev2
LIFETIME WARRANTY FOR ALL MOUNTING COMPONENTS.
TWO YEAR WARRANTY ON ALL INTERNAL ELECTRONICS.
The exclusive NPI Lifetime Warranty states that all RAM mounting components and parts are warranted against defects in materials and workmanship for
the life of the component or part. NPI’s Lifetime Warranty covers the mount or its components only. The mounted device is not covered under the Lifetime
Warranty and will not be replaced if damaged as a result of mount failure. This warranty is expressly limited to the persons in the United States, and all
foreign countries who purchase RAM for resale or use in the ordinary course of the buyer’s business. This warranty does not cover any component or
part that has been abused, worn out, heated, ground or otherwise altered, used for a purpose other than that for which it was intended, or used in a
manner inconsistent with any instructions regarding it’s use.
GET2 Tough Dock User Guide for Getac B300
Port Replicator:
(All functions labeled on dock)
Speaker: Speaker/Headphone
Stereo phono jack
Network: RJ45 connection
Video: VGA out D-sub 15 pin Serial: Serial port D-sub 9 pin
USB: qty. 4 External USB 2.0
USB: qty. 1 External USB 2.0