Ram drill seat bases – RAM Mount RAM-VBD-126-SW1 User Manual
Page 2
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Determine the best location for the base on the transmission hump.
2. Locate base on hump with floor pan flange orientated on the passenger side of the vehicle. Make sure that the
hump flanges are in contact with the top of the hump.
3. Mark mounting holes and check to see if any edges of the base need to be shimmed.
4. Drill 13/32” holes at each of the marked locations. Please be careful not to damage any equipment that might be
underneath the floor boards.
5. Attach base with bolts, washers, and nuts. Do not use sheet metal screws. If floor is less than 1/4” thick, please use
fender washers to help disperse the weight.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM Drill Seat Bases
National Products, Inc.
Item Number
RAM-VBD-126
FORD BRONCO (1996-OLDER)
FORD EXPEDITION (1996-OLDER)
FORD F-150 (1996-OLDER)
FORD F-250 (1996-OLDER)