RAM Mount RAM-VB-121-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Remove the seat bolts that hold the right side of the driver’s seat to the floor.
2. Loosely assemble legs to the base. Do not firmly tighten.
3. Place mounting base to the right side of the driver’s seat. Align mounting legs to the seat bolt holes and tighten
in place.
4. Gently lift the inside of the seat upward to allow the seat frame to clear the studs.
5. Place the base between the seat frame and align the holes in the base with the seat studs.
6. Lower the seat back down over the No-Drill™ base and seat studs.
7. Fully tighten factory hardware to secure base in place along with seat frame.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-121
CHRYSLER TOWN & COUNTRY (1996-2004)
PLYMOUTH VOYAGER (1996-2001)
DODGE CARAVAN (1996-2007)