RAM Mount RAM-VB-156-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Note: Depending on the vehicle trim level, there may be plastic covers over the seat frame legs. This will need to be
removed in order to install the base. Once installed, these can sometimes be replaces. Otherwise, store them for use
later should the base be removed.
1. Move the passenger seat back to its rearmost position and loosen the front seat rail bolts or nuts. It may be
necessary to loosen the two nuts or bolts at the rear of the seat as well for some vehicles in order to raise the front of
the seat enough to clear the No-Drill™ base.
2. Gently lift the front of the seat to create a small gap between the seat frame and seat track.
3. Align the slots in the base with the seat bolts and slide the base into place. Press the No-Drill™ base as far in as
possible so that the back of the slots engage the seat bolts. The pedestal platform should be near the console.
4. Re-tighten the bolts or nuts to secure the no drill base in place.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-156
HYUNDAI AZERA (2006-2009)
HYUNDAI ELANTRA (2005-2011)
HYUNDAI SONATA (2005-2009)
KIA OPTIMA (2005-2009)