RAM Mount RAM-VB-165-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Tools suggested for this installation are an 18MM socket wrench.
1. Using a socket wrench, remove the two seat rail bolts that hold the seat frame to the floor board. These are
located at the bottom front of the passenger seat.
2. Once the seat bolts are removed, set them aside.
3. Place the No-Drill™ base with the mounting platform closest to the center hump.
4. Align the holes in the No-Drill™ base with those in the floor board.
5. Pass the factory seat rail bolts through the No-Drill™ base and partially re-thread them into the floor board by hand.
6. Once both bolts have been started by hand, use the socket wrench to re-tighten.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-165
HUMMER H3 (2006-2009)