RAM Mount RAM-VB-131A-SW1 - Manual

Installs in minutes with no drilling required
Won’t interfere with levers, factory-installed console, or 4WD lever
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side, in front, where seat frame meets
floor board.
Drilling Required
None - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
Hole Center = 15”
Tools required for base installation
Deep 9/16” hex socket , and socket wrench for base
installation . Tools for complete system
assembly: pliers, phillips screw driver, #10, ½”,
9/16” box end wrench’s.
Pole or Pedestal
Ordered Separately
Weight
6.8 lbs.
RAM ADJUST-A-POLE
TM
Included With Base
Features
Shown In Use
Misc.
Rock solid construction
Lifetime warranty
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-131A
RAM-VB-131A
GMC SIERRA (DELUXE POWER SEATS)
(2000-
)
GMC YUKON (DELUXE POWER SEATS)
(2000-2006)
CHEVROLET SILVERADO (DELUXE POWER SEATS)
(1999-2006)
CHEVROLET SUBURBAN (DELUXE POWER SEATS)
(2000-2006)
2006
CHEVROLET 2500 & 3500 C/K SERIES TRUCK (DELUXE
POWER SEATS) (2000-
)
CHEVROLET AVALANCHE (2000-2006)
HUMMER H2 (2005-2009)
2006