RAM Mount RAM-VB-148-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Move the seat to its rear most position.
2. Loosen the front bolts that hold the seat frame legs to the floor board. The bolts only need to be loosened enough to
to allow the base to slide in between the legs and the floor board.
3. Slide the No Drill base into place making sure the shove the base back so the bolts engage the rear of the slots.
Please Note: If the seat is moved completely forward, the mounted equipment could possibly hit the dash. Once the
base is installed, use caution when adjusting the passenger side seat.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-148
FORD FOCUS (2003-2010)