RAM Mount RAM-VB-137ST1-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. If using a riser, it should be attached to the No-Drill™ base prior to attaching the base to the vehicle. For a finished
look, assemble so the rounded heads of the carriage bolts are on top. A riser is not necessary for most applications.
2. Move the passenger seat back to its rearmost position and remove the front seat rail bolts using a 14mm socket
wrench. Save and store these bolts should the mount be later removed.
3. Using the provided hardware, place the washers over the longer bolts, pass the bolts through the No-Drill™ base,
next through the round stand-offs, and align over the threaded holes in the floor board.
4. Start bolts by hand to insure that the bolts do not cross thread
5. Using a 17mm socket wrench, fully tighten the bolts to secure the base.
6. After a day of use, re-tighten the seat bolts holding the mount in place.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-137ST1
TOYOTA TUNDRA (2000-2006)