RAM Mount RAM-VB-169-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Note that stand offs and longer bolts are used for Honda Accord. Place the stand offs in between the base
and the seat frame legs. Pass the longer bolts provided through the base, then the stand offs, and start the thread by
hand into the floor board. Once started, use a socket wrench to fully tighten. Stand offs are so base clears air duct.
1. Move the passenger seat back to its rearmost position and remove the front seat rail bolts.
2. Without moving the seat, place the No-Drill™ base over the front of the seat frame legs.
3. Align the holes in the base with those of the seat frame legs. The pedestal platform should be near the console.
4. Re-install the seat bolts and fully tighten.
No-Drill™
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-169
HONDA ACCORD (2008-2010)
SUBARU FORESTER (2006-2009)
SUBARU IMPREZA (2006-2010)
SUBARU LEGACY (2006-2009)
SUBARU OUTBACK (2006-2009)