RAM Mount RAM-VB-170-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Locate and remove the two front seat rail bolts holding the passenger side seat to the floor board.
2. Place the No-Drill™ base over the inner most seat frame leg and under the outer most seat frame leg nearest the
door.
3. Align the holes in the base with those of the seat frame legs.
4. Replace the two bolts and fully tighten.
5. After a week of use or a day of off road use, check seat leg bolts and retighten if necessary.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-170 & RAM-VB-170-SW1
JEEP WRANGLER RUBICON (2007-2013)
JEEP WRANGLER SAHARA (2007-2013)
JEEP WRANGLER SPORT (2007-2013)
JEEP WRANGLER UNLIMITED (2007-2013)