RAM Mount RAM-VB-163-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Depending on your make and model, there may be a piece of plastic trim that covers the lower front of the seat frame.
This will need to be removed and stored. If you wish to reinstall this piece of trim, you will have to modify it to fit over
the stamped metal base.
1. Assemble the Adjust-A-Pole
TM
riser and attach to the stamped metal base. Do so with the carriage bolts
passing down through the base so the nuts are on the bottom.
2.
To the upper half of the Adjust-A-Pole
TM
, attach the lower female tube that is part of the Tele-Pole assembly.
Do so with the carriage bolts passing downward so the rounded part of the bolt is on top. Once completed, set aside.
3.
Locate the two front seat rail bolts holding the passenger seat in place.
4. Using a 14MM socket, remove the two seat rail bolts and set them aside.
5. Place the stamped metal base under the seat with the mounting holes over those of the seat rail frame.
6. Re-install the 14MM seat rail bolts and tighten.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-163
ACURA MDX (2001-2006)
HONDA PILOT (2005-2008)