beautypg.com

Installing the lock collar installing the pulley, Assembly & installation – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 User Manual

Page 28

background image

28

PNEG-1435 6", 8" & 10" Utility & Bulk Augers

4. ASSEMBLY & INSTALLATION

Installing the Lock Collar

1. Slide the Lock Collar over the Drive Shaft, positioning it against the bearing. Do not tighten

the lock collar at this time as it will be tightened later in the assembly

(See Figure 4R)

.

Figure 4R

Installing the Pulley

1. Place and position the key into the keyway located on the Drive Shaft.

2. Place the pulley onto the Drive Shaft with the setscrew side of the pulley facing away from

the Bearing Plate. Position the pulley so that it is as close to the lock collar as possible, but
not touching it.

Drive Shaft

Lock Collar

See also other documents in the category Grain Systems Equipment: