Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 24)

24 PNEG-1435 6", 8" & 10" Utility & Bulk Augers
4. ASSEMBLY & INSTALLATION
Installing Bearing Plate onto Tube
1. Align Bearing with Drive Shaft and slip Shaft through bearing.
2. Rotate Plate until bolt holes in tube flange and plate align. Secure with appropriate bolts,
and Serrated Flange Nuts (See Chart) .
3. Only Secure With UPPER and LOWER four(4) bolts (Figure 4M) . The other four (4) bolts
will be installed later with the Belt Guard Mounting Brackets.
Figure 4M
Note: On the 10" systems use the four (4) 3/8" x 1" – 16 bolts in this step, the longer bolts
will be used to attach the Belt Guard Mounting Brackets in a future step.
Bearing Plate Bolts
6" & 8" 5/16" x 1" - 18 Hex Bolts
10'' 3/8" x1" - 1/14'' - 16 Hex Bolts
10" 3/8" x 1" - 16 Hex Bolts
[ (See Chart) for bolt sizes]
Bearing Plate
Drive Shaft
Bolts
Serrated Flange Nut