Vision control panel – Grain Systems PNEG-1459 User Manual
Page 10
10
PNEG-1459 L Series Operators
VISION CONTROL PANEL
LOAD AUGER SWITCH
This is used to select the operation of the fill auger. In both the auto and manual position the load auger will operate if the dryer
is low on grain and will automatically shut off when the dryer is full. In the auto position only the dryer will shut down after a
preset period of time set on the out of grain timer if grain flow is interrupted to the dryer. The load delay is disabled when the
load auger switch is in the manual position. The switch will light whenever the load auger is operating.
Note: If the load auxiliary controls are being used, this switch will also control the operation of the auxiliary equipment.
UNLOAD SWITCH
The unload switch turns the metering rolls and discharge auger on or off, and selects the operation of the metering rolls. In the
manual position the meter rolls will operate in 1 speed only. In the auto position the meter rolls switch to a multi-speed mode
for moisture control operation. The switch will light whenever the load auger is operating.
Note: If the unload auxiliary controls are being used, this switch will also control the operation of the auxiliary equip-
ment.
OUTSIDE LIGHT SWITCH
The dryers outside service light is turned on or off here. It also may be set on auto, which turns the light on while the dryer is
running and off if a shutdown occurs.
START SWITCH
This switch starts and operates the dryer based on switch settings. If other switch settings are in the off position, individual
dryer components can be operated by turning the drying mode switch to continuous flow, pressing the dryer power run button
and then turning on the desired dryer component.
STOP SWITCH
This switch stops all dryer functions. If an automatic dryer shutdown occurs, first determine and correct the cause of the
shutdown. Then, press the dryer power stop button to reset the dryer before restarting.