beautypg.com

Chapter 8: accessories – Grain Systems Tanks PNEG-4054A User Manual

Page 129

background image

Chapter 8: Accessories

Figure 8-6 Using the roof exhauster flashing and mounting plate as a template

E

5/16 in. flange nut (S-3611)

K

Roof panel

F

Exhauster mounting plate

I

Marked or scribed hole to be cut

G

5/16 x 1 in hex bolt (S-10260)

J

Field bent inside tab on roof exhauster mounting
plate

H

Holes to be field drilled

4. Bend the tabs (J) downward approximately 90 degrees on the roof exhauster mounting plate (F) to

conform with the roof panel.

NOTE: Bend the tabs on the ground and adjust as necessary once on the roof.

5. Remove the roof exhauster mounting plate (F), to make the necessary cut along the mark or scribe

(I).

Pneg-4054A 54 Ft Diameter 40-Series Bin

129

See also other documents in the category Grain Systems Equipment: