Grain Systems Tanks PNEG-4054A - Manual (Page 106)

Chapter 7: Roof Assembly
NOTE: Ensure that the orientation of the roof panel clip is correct, roof panel holes facing the roof
and the notch in the roof panel clip is facing the right-hand roof rafter.
3. Tighten all hardware to the recommended torque specifications only after the roof panels are
installed. See Bolt Torque Specifications, page 28 .
Figure 7-24 Roof panel clip
A Left-hand roof rafter (CTR-0582) D 7/16 x 1-1/4 in. flange bolt (S-10250)
B Roof panel clip (CTR-0410) E 7/16 in. flange nut (S-10251)
C Right-hand roof rafter (CTR-0582)
After You Finish
Repeat this procedure for the remaining roof panel clips.
106 Pneg-4054A 54 Ft Diameter 40-Series Bin