Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1391 - Manual (Page 19)

19
Assembly
PNEG-1391 8",10", & 12" BE-SAW Augers
3. ASSEMBLE 8", 10", & 12" HOPPER RUBBER BELTING ASSEMBLY
Swing-Out
Hopper
Rubber
Hopper
Belting
Attachment
Clips
A. Place the rubber belting into the inside of the swing-away hopper.
B. Loosely attach the rubber belting using ten (10) attachment clips and two (2) 1/4” x 1” long hex head
cap screws and nylon locknuts for each clip. The points of the clips should point up and the bolt
heads should be inside the hopper. Use the bolt holes positioned around the upper edge of the
hopper as a guide.
C. Position the belting inside the clips with the belting edge resting on the bolts. As shown on the diagram
on the previous page, the belting should not cover the output end of the hopper. Keep the belting end
within one (1) inch of the clip end.
D. Position the belting evenly around the hopper and through the corners.
E. Tighten the bolts and nuts so that the clip points draw into the belting and the smooth edge of the clips
is in contact with the belting.
1/4" x 1" Hex Head
Capscrew and Nylon
Locknut
Attachment Clip
Rubber
Belting
Hopper
1/4"
Nut
1/4" x 1"
Hex Head
Cap
FIGURE 3-B
Belt Hopper Detail
FIG. 3-A