Grain Systems Unload Augers PNEG-1430 - Manual (Page 24)

24 PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader
8. Shut Down
Normal Shut Down
A. Before shutting down the unit, be sure the hoppers and augers are empty.
B. Disconnect and lock out the power source before leaving the work area.
Emergency Shut Down
A. Know how to shut down the auger in case of an emergency.
B. Do not re-start the auger when it is under load.
C. Close the bin well control gates.
D. Re-connect and unlock the power source.
E. Clear the auger gradually until there is no grain and there are no obstructions.
Storage Preparation
A. Close all wells to the discharge auger.
B. Be sure the unload tube is empty.
C. Shut down the auger.
D. Make sure all fasteners are tight.
CAUTION
NEVER start the equipment under load. Doing so may cause damage. This type of
damage is considered a misuse of the equipment. Any misuse of the equipment
may void the warranty.