beautypg.com

Installing the belt guard – Grain Systems Unload Augers PNEG-1430 User Manual

Page 19

background image

4. Assembly

PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader

19

Installing the Belt Guard

1. With the belts properly tensioned, remove the bottom belt guard cover and slip belt guard down over

motor shaft.

2. Bolt the belt guard to the belt guard mounting brackets. Note that the brackets should still be loose

at this time.

3. Align the motor shaft and the flight drive shaft in the belt guard’s slot, making sure that the belt guard

DOES NOT contact either pulley or shaft and tighten down the belt guard mounting brackets to the
bearing plate.

(See Figure 4K.)

4. Once the brackets are tightened, slide the bottom cover back into place and secure with supplied bolt.

Figure 4K

See also other documents in the category Grain Systems Equipment: