Grain Systems Tanks PNEG-4135 - Manual (Page 115)

Chapter 7: Roof Assembly
NOTE: Eyebolt will pass through three layers of steel: the splice plate (V), the center cap plates (L
and M), and the long center collar channels (I).
32.Tighten all hardware to the recommended torque specifications. See Bolt Torque Specifications,
page 26 .
Figure 7-29 Installing the cap plates
A 3/8 in. nut (S-456) Q Side cap plate (CTR-0360)
L Center cap plate (CTR-0281) R Side cap plate (CTR-0323)
M Center cap plate (CTR-0325) S Side cap plate (CTR-0324)
N Tube caulk V Splice plate (CTR-0326)
P 3/8 x 1 in. bolt with sealing washer (S-7487) W Vendor lifting eyebolt
Assembling the Center Collar
The center collar assembles each A-frame roof rafter section together at the top. The center collar assem-
bly is a three piece design and will need to be spliced together with splice plates.
Before You Begin
Pneg-4135 135 Ft Diameter 40-Series Bin 115