Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1056 - Manual (Page 24)

- 24 -
Insert key into shaft. Slide sprocket onto the tail shaft. DO NOT TIGHTEN setscrews at this
time. After final assembly of tail section unit, the sprocket must be centered between the side
panels before tightened into place.
Place UHMW (white plastic square with large hole) seal onto each end of shaft/sprocket
assembly. Insert each end of shaft/sprocket assembly into properly sized pillow block bearing.
DO NOT TIGHTEN setscrews at this time.
Slide above assembly into slot at end of tail until pillow block bearings can be mounted onto
the bearing weldments with the bolt, flat washers, lock washers, and nuts provided in the
hardware bag.
Bolt seal retainer bracket and false panel in place using 5/16” hex head bolts and 5/16” whiz
nuts. Fasten false panel and false panel bracket to tail side panels with 3/8” carriage bolts and
3/8” whiz nuts. Position seal retainer angle inside seal retainer bracket and push towards tail
side panel to secure the tail shaft seal. Secure the seal retainer angle in place with 5/16” hex
head bolts and 5/16” whiz nuts. Attach end panel to side panels of tail with 3/8” hex head bolts
and 3/8” whiz nuts.
Center sprocket between tail panels and tighten all setscrews.
Place cover assembly on top of conveyor and fasten with 3/8” hex head bolts and 3/8” whiz
nuts.