Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1056 - Manual (Page 16)

- 16 -
Drive Package Assembly
Using hardware provided, attach motor mount angles to
motor mount adapter. There are only two motor mount
angles on reducers up to a 3 7/16” bore. For reducers with 3
15/16” bore and larger there are four motor mount angles.
Attach motor base to motor mount adapter using
all-thread rods (4) and nuts (16) provided in hardware
package. (Note orientation of motor base.)
Attach this assembly to the reducer, using the existing
bolts in the reducer. The angles should be mounted on the
same side as the input shaft.
Remove any rust, paint or imperfections from the drive
shaft. The drive shaft must be clean and shiny before
installing the reducer drive.
Slide the reducer bushing onto the shaft.
Mount the reducer onto the drive shaft and fasten in place
using the reducer bushing and cap screws provided. Do not
tighten the bushing cap screws until the end of the drive
shaft is protruding through reducer at least a 1/8”. Make
sure adequate space remains between the bearing and the
reducer bushing to allow removal of the bushing cap screws.