Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1056 - Manual (Page 21)

- 21 -
Care and Maintenance
The care and maintenance section is provided with the intention of helping to extend the useful
life of the unit. Like all equipment, the useful life of the conveyor is greatly reduced if not used
wisely and well maintained.
Before any maintenance is performed to the conveyor,
power must be shut off and locked out to prevent
accidental start up!
Check oil level in shaft mount reducer periodically. Fill to level as recommend by
Manufacturer.
Check all bearings and moving parts daily during use.
Follow bearing manufacturer recommendations.
Lubricate all greasable fittings two to three times during the use season. Use a good grade
lubricant. Do not over-lubricate.
The V-belt(s) should be periodically inspected for proper tension and wear. V-belts should be
replaced as necessary. If replacement or tension adjustment is required, refer to the Assembly
Section(s).
The drag chain and sprockets should be checked periodically for wear, damage, and proper
adjustment. Any broken or bent paddles should be replaced or straightened. Should adjustment
or replacement of the drag chain or sprockets be required, refer to the Assembly Section(s).
Storage
If the unit is to be inactive for an extended period, the following procedures are recommended.
Thoroughly clean the unit.
Loosen the drag chain tension. Doing so relieves the stress placed on the bearings and shafts of
the drive and tail sections.
Lubricate drag chains, shafts, and drive components with a good grade of light machine oil.