Grain Systems Unload Augers PNEG-1722 - Manual (Page 21)

PNEG-1722 Series II Sweep Protected Cord Slip Ring Sump 21
5. Start-up
Preform Pre-start Checks
1. Make sure ALL shields are in place.
2. Inspect the collector ring for any problems or potential problems.
3. Be aware of any emergency shut down procedures. Two (2) people must always be in a position
where the operation of the equipment can be monitored.
4. Before starting the auger for the first time, make sure that all parts are assembled correctly
according to the instructions in this manual.
To ensure that the drive is not unexpectedly started, turn OFF and lock out or tag
out the power source before proceeding. Failure to observe these precautions
could result in bodily injury.
Failure to perform any or all of these pre-start checks may cause damage to the
equipment and/or cause SERIOUS INJURY or DEATH to those in the work area.
Failure to perform any or all of these pre-start checks may also be a misuse
of the equipment. Any misuse of the equipment may void the warranty.
ALWAYS keep ALL guards and shields in place, until all the power is
disconnected and locked out.
Make certain ONLY trained operators are in the work area before operating or
moving the machine. Two (2) people must always be in a position where the
operation of the equipment can be monitored.