Grain Systems Bin Accessories PNEG-914 - Manual (Page 6)

1. Safety
6 PNEG-914 Flex-Flo
General Safety Statement
Our foremost concern is your safety and the safety of others associated with grain handling equipment.
This manual is to help you understand safe operating procedures and some problems which may be
encountered by the operator and other personnel.
As owner and/or operator, you are responsible to know what requirements, hazards and precautions exist
and inform all personnel associated with the equipment or in the area. Safety precautions may be required
from the personnel. Avoid any alterations to the equipment, which may produce a very dangerous
situation, where SERIOUS INJURY or DEATH may occur.
Electrical Safety
An adequate and safe power supply to the Flex-Flo System unit is essential for safety. A competent and
qualified electrician must undertake all electrical wiring. All wiring is to be installed in accordance with all
local and National Standards and Regulations relevant to your country and region.
Electrical safety devices, emergency stops and main isolators are recommended with the Flex-Flo System
and are essential for safety. This should be installed as indicated in the enclosed installation instructions
and in accordance with the relevant codes and directives.
User’s Manual
This manual contains information and instructions essential to the safe installation and use of the
Flex-Flo System. Read this manual thoroughly before attempting any installation or use of the
Flex-Flo System. Keep this manual with the Flex-Flo System or in a location where it can be readily
accessed. Failure to read this manual and its safety instructions is a misuse of the equipment.
Correct Uses of the Flex-Flo System
The Flex-Flo System is designed for the sole purpose of conveying granular or powdered agricultural
animal feed. Use of the system in any other way is a misuse of the system and may endanger the health
and safety.
Only genuine AP/Cumberland parts are to be used in the installation and use of the Flex-Flo System.
Use of other non-genuine parts is a misuse of the system and may lead to dangerous situations imperilling
the safety and health of you and others.
This system is not designed for use in atmospheres where there is a risk of explosion. Use in such an
environment is prohibited. If in doubt contact your dealer or the GSI group.
Safety Guards
The Flex-Flo System contains many moving and electrical parts, which will cause serious injury or death
if touched. Guards are placed on the machine to protect you. Operating the machine at any time with
guards removed or incorrectly fitted is a serious misuse of the machine and endangers safety.
Safety in Handling the Flex-Flo System
The Flex-Flo drive unit weighs 48 lbs. (22 kgs). All precautions should be taken when lifting and or moving
the unit. Ideally mechanical lift equipment should be used. If manual handling is necessary assistance
should be sought from other people.