Grain Systems Tanks PNEG-1070 - Manual (Page 37)

5. 15'-24' Hopper Assembly
PNEG-1070 15', 18', 21', 24', 27' and 30' CHT’s 37
Install “X” bracing rods as in Figure 5J , Figure 5K and Figure 5L .
When the hopper structure has been completed, it should be level to within ± 1/8" maximum deviation, as
compared to all other support columns as measured at the top of the compression angle ring. The support
columns must be plumb to within ± 1/2" as measured from top to bottom. Seal any gaps between
compression elements and the seal strip at column locations with silicon or other conventional means.
Figure 5J Completed Hopper Assembly
Figure 5K “X” Bracing Rods Figure 5L