Grain Systems Tanks PNEG-1070 - Manual (Page 33)

PNEG-1070 15', 18', 21', 24', 27' and 30' CHT’s 33
5. 15'-24' Hopper Assembly
Hopper Section Assembly 15'-24' (4.57 m-7.32 m) Diameter
Hopper Tanks
Before placing the support columns on the anchor bolts, use a transit and surveyor’s rod to locate high
and low areas in the concrete. To assure level alignment for the support columns, use the proper supplied
shim or shims between the concrete and base plate. After leveling is completed, place the support
columns over the anchor bolts, with shim plates underneath column. Next place HT-635 washer over
anchor bolts and loosely fasten with nuts and washers (not furnished). Refer to
Figure 5A .
NOTE: 15' (4.57 m) Diameter hopper tanks have 10 columns.
18' (5.49 m) Diameter hopper tanks have 12 columns.
21' (6.40 m) Diameter hopper tanks have 14 columns.
24' (7.32 m) Diameter hopper tanks have 16 columns.
Figure 5A