Danze D423058 - Installation Manual User Manual

Page 8

Select location on side wall of cabinet that will let
you easily service the battery pack and adjust the
temperature of the water. Position the sensor box
on wall. Attach sensor control box to wall with
mounting screws.

Note: Sensor control box should be mounted as
close to front of cabinet as possible for easy valve
adjustments and battery service.

7.2.a

7.2.b

7.2.c

7.2 FOR DC POWER OPERATION:
a. Remove the cover from sensor control box by using
screwdriver. Take the rubber grommet with one hole
out of the box. Note: the "ON-OFF" switch should
be turned to OFF(O) position during installation.
b. Connect sensor lead from spout to sensor connection
in box. Insert sensor lead wire into the rubber
grommet with one hole. Locate grommet between
sensor and connection. Reinstall it to the lower slot.
Install the grommet without hole to the upper slot.

c. Install 4 1.5V "C'' sized alkaline batteries to make
sure the required battery polarity on battery holder.
Place the battery holder into the sensor control box.
Arrange wire and connection joint inside box, then
reinstall cover.

Wall

Grommet without hole

Be sure to place wire
joints inside the box
before closing.