Tools required before you begin, Operation manual – Danze D423058 - Installation Manual User Manual

Page 3

Tools Required

Before you begin

This faucet is designed to be installed in 1 1/2" diameter faucet mounting holes. Typical installation uses 3 mounting holes lo

cated 4" center to center

with the fittings mounted per the illustrations. Because the spout, hand valve, and spray are connected below the sink by hose

s, you have flexibility to

locate these fittings in different order or location to suit the user. The hands free sensor should be oriented to avoid accide

ntal triggering. See further

notes below.

Shut off main water supply before installation.

The power to the hands free mechanism can be supplied using battery pack (DC), or from your 110V household current (AC) using t

he power cord

with transformer supplied.

Operation Manual

INSTALL SPOUT ASSEMBLY:
Place the spout into the hole of sink. The sensor window should be oriented to the
location best suited to the user to activate the faucet while limiting the possibility of
accidental activation. For double bowl sinks, often best location is directly over the sink
separation; for single bowl sinks, often best orientation is 45 degrees away from the
sink. Attach the rubber washer, plastic wire washer, metal washer and brass lock nut
to the spout shank. A protective film over the sensor window can be removed after
installation is complete.

NOTE: The rubber washer and plastic wire washer are designed to allow passage of
the wire. Insert properly to avoid pinching wires. Position carefully the wire washer,
slip up the flat washer and screw the lock nut until snug. Verify again for correct wire
clearance and tighten nut as required.

Adjustable wrench

Channel lock plier

Philips screwdriver

C Style 1.5 Volt battery