Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Power Systems- PowerPack, Stinger-Plus, Stinger & Git-Kit '19991_2-2003 F-250 & F-350 Trucks and Excursions - Manual (Page 20)

20
96336 v.10.0
Section 11
RESToRING FACToRy TuNE
The stock calibration can be reinstalled
at any time by following the instructions
below. This feature will remove the
Banks AutoMind calibration and will
return the vehicle to its stock condition.
The Banks AutoMind calibration will
be saved in the Banks AutoMind
programmer.
1.
Plug the OBD II connector from your
Banks AutoMind programmer into the
OBDII connection port of your vehicle.
2.
Choose ‘TUNE VEHICLE’ in the main
menu screen and press the ‘OK’ button.
3.
Select ‘QUICK TUNE’ and press ‘OK’ to
continue.
4.
Scroll up or down to highlight the
‘Stock’ calibration and press the ‘OK’
button. See Figure 14 .
5.
Press the ‘OK’ button to continue
restoring stock calibration or ‘Left’
button to abort and go to the previous
menu.
6.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine.
wARNING: unplugging the
Banks AutoMind Programmer
while uploading or downloading
a calibration can damage the
vehicles ECM.
7.
The data transfer may take a few
minutes to complete. Once the upload is
complete you will be instructed to “Turn
Ignition Switch OFF and Remove Key,
Press OK to continue.” See Figure 13 .
8.
The original factory stock calibration
restoration is complete. You may unplug
the Banks AutoMind Programmer and
drive your vehicle.
-END, SECTION 11-
Figure 14
Section 12
DIAGNoSTICS
The diagnostic feature on the Banks
AutoMind programmer allows you to
read and clear Diagnostic Trouble Codes
(DTCs) and aids in Troubleshooting.
1.
Plug the OBD II connector from your
Banks AutoMind programmer into the
OBDII connection port of your vehicle.
2.
After the welcome screen, scroll up
or down in the main menu screen and
highlight to select ‘ADDITIONAL FEATURES’
and press the ‘OK’ button. See Figure 15 .
3.
Scroll through the ‘ADDITIONAL
FEATURES’ screen using the up and
down button keys to view the options.
4.
Highlight ‘Diagnostics’ and press the
‘OK’ button.
5.
Highlight to select ‘Read DTCs’ and
press the ‘OK’ button. See Figure 16 .
6.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine. Then press the
‘OK’ button.
7.
Scroll up or down to view any
displayed DTC along with a description.
Press the ‘Left’ button to EXIT.
8.
To remove Diagnostic Trouble Codes
(DTC) press the ‘OK’ button to return to
the ‘Diagnostics’ menu and scroll down
to ‘Clear DTCs’. Press the ‘OK’ button.
See Figure 17 .
9.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine. Then press the ‘OK’
button.
10.
Screen will announce that the
DTCs have been cleared. Follow the
on screen instructions and turn the
ignition key OFF, when prompted by
the programmer. Then press the ‘OK’
button to EXIT and go to the previous
menu.
-END, SECTION 12-
Figure 15
Figure 16
Figure 17