Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 37)

96816 v.3.0
37
If the Banks EconoMind Diesel Tuner
has been moved to a different
vehicle, or you are instructed to
do so by Banks Technical Staff,
it is possible to reset all of the
parameters that the EconoMind has
‘learned’.
CauTION: The following
procedures can only be carried
out with the engine OFF!
1.
Turn the vehicle key to ON but DO
NOT start the engine.
2.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times. The GREEN LED
will flash when this is completed
successfully.
3.
Turn the key OFF. Wait 30
seconds, or until the GREEN LED goes
off and stays off. Turn the key back
to the ON position but DO NOT start
the engine.
4.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times
-END, SEcTION 11-
If the Banks EconoMind Diesel Tuner
should ever need to be removed
from the vehicle, perform the
following:
1.
Disconnect the EconoMind’s
38-pin connector from the factory
harness.
2.
Re-connect the vehicle’s 38-pin
connector back into the factory
harness.
3.
Disconnect the EconoMind’s
24-pin connector from the factory
harness.
4.
Re-connect the vehicle’s 24-pin
connector back into the factory
harness.
5.
Disconnect the 2-ring terminals
from the EGT thermocouple.
6.
Disconnect the 3 small connectors
on the ‘In-Cab Cable’ and gently pull
the cable back through the firewall.
7.
Remove the Banks EconoMind
Diesel Tuner.
NOte: Failure to follow the above
instructions when removing the
module will result in a “Check
engine” light on the dash and a
Diagnostic trouble Code being stored
in the factory computer, in addition
to the engine not running.
-END, SEcTION 12-
Notification
The Banks Ram-air Filter comes
pre-oiled and no oiling is
necessary for initial installation.
Service the filter as specified in
this Section of this manual. 1.
Service Banks Ram Air Filter every
50-100,000 miles on street-driven
applications. Service more often in
off-road or heavy-dust conditions.
If an air-filter restriction gauge is
installed, then clean the element
when the air-filter restriction gauge
enters the restrictive red zone. See
Figure 13.1.
2.
Use Banks Ram Air Filter cleaning
system (part # 90094), available from
Gale Banks Engineering to service
the Air Filter. Follow the instructions
included with the cleaning system
to clean and re-oil your Banks Ram
Air Filter. No gasoline cleaning, No
steam cleaning, No caustic cleaning
solutions, No strong detergents, No
high pressure car wash, No parts
cleaning solvents. Any of these No’s
can cause harm to the cotton filter
media plus SHRINK and HARDEN the
rubber end caps.
CauTION! Extremely fine dust
from agriculture or off-road
use will pull the oil from the
element. Frequent re-oiling of
the element’s clean side might
be required. Completely service
when practicable. For extra
protection use an air-filter sealing
grease on rubber ends of the
element. Service only with Banks
Ram-air-filter cleaner and Banks
Ram-air-filter oil.
-END, SEcTION 13-
Section 11
CLEaRING LEaRNED PaRaMETERS
Section 12
REMOVaL OF THE ECONOMIND DIESEL TuNER
Section 13
FILTER MaINTENaNCE
AIR-FILTER
RESTRICTION
GAUGE
RESTRICTIVE
RED ZONE
Figure 13.1 typical air-filter restriction gauge