Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w EconoMind (LLY & LBZ) '06-07 (iQ) Compatible with Optional Banks iQ - Manual (Page 29)

96816 v.3.0
29
Section 6 not needed if installing
the Power Level Selector Switch. If
this is the case, please proceed to
Section 7.
WaRNING: Below 32 o F (0 o C) or
above 140 o F (60 o C), the Banks iQ
may be susceptible to damage
as a result of extended direct
exposure to sunlight, heat,
or extreme cold. It is highly
recommended that the Banks iQ
be removed from its mounting
location if the vehicle will be
subjected to these conditions
for an extended period of time.
Gale Banks Engineering is not
responsible for damage to Banks
iQ resulting from exposure
conditions.
CauTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
Locate the Window Mount
Assembly in your kit.
2.
Assemble the Banks iQ docking
station to the Universal mount by
inserting and sliding the Universal
mount tab into the docking station
groove. Hand tighten the nut behind
the docking station to hold the
docking station in place.
3.
Attach the window mount to your
Banks iQ. See Figure 6.1. Align and
place the two (2) lower tabs on the
window mount to the corresponding
slots on the bottom of Banks iQ first
then snap the top of Banks iQ into
place.
NOte: there may be a snug fit when
installing the Banks iQ into the window
mount. take care not to force this
process.
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 6.2 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note
the angle necessary to achieve the
correct viewing angle.
5.
Make sure the suction cup and
the mounting area on the windshield
are clean and dry. With the suction
lever in the up position, ensure
the suction cup is flat against the
windshield, and then push the
suction lever down to secure in
place.
6.
Next, remove and set the fuse
access panel aside. See Figure 6.2.
7.
Locate the Banks OBD II Interface
Cable in your kit. This cable has
three connection points. Connect
the RED OBD II connector on the
Banks interface cable to the vehicle
OBD II connector. Use a cable tie as
shown in Figure 6.3 to secure the
Banks interface cable to the vehicle
OBD II connector. Next, connect the
6-pin connector on the Banks OBD II
interface cable to the 6-pin connector
on the EconoMind Tuner harness.
Section 6
MOuNTING aND CONNECTING THE BaNkS iQ
Figure 6.1 Attaching Banks iQ to window mount
Figure 6.2 Mounting location for Banks iQ, Chevy LMM Shown.