Daystar KJ71020CAMO - Manual (Page 2)

Thank you for choosing Daystar
Daystar recommends a certified technician install this system . In addition to these
instructions , professional knowledge of disassemble/reassembly procedures as well
as post instruction checks must be known. Attempts to install this system without
this knowledge and expertise may jeopardize the integrity and/or operating of the
vehicle.
Please read all the instructions before beginning the installation. Check the kit hard-
ware against the parts list. Be sure you have all the needed parts and understand
where they go. If anything is missing , do not proceed with the installation, Call
Daystar Products to obtain needed item
s.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly recom-
mend , because of rollover possibility, that Seat belts and shoulder harness be worn
at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/heaver
tires and wheels are used. Take this into consideration while driving, also , speed-
ometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase vehi-
cle height over the intended height of the Daystar Product purchased. Mixing com-
ponent brands, lifts, and/or combining body lift with suspension lift voids all war-
ranties. Daystar makes no claims regarding lifting devices and excludes any and all
implied claims. We will not be responsible for any products that are altered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to driver”
decal installed on the sun visor or dash. The decal is to act a constant reminder for
whoever is operating the vehicle of its unique handling characteristics. INSTALL-
ING DEALER— Its is your responsibility to install the warning decal and forward
these instructions on too the vehicle owner for review and to be kept in the vehicle
for service life.
After installation occurs, a qualified alignment facility is required to align the vehi-
cle to factory specs.
9. Using your hand push down on the back of the panel so the 2 clips will
latch down.
10. With the panel installed you can use your favorite electronic devices.