VANCO VPW-280755 - Manual (Page 14)

VPW-280755 EDID DIP SWITCH SETTINGS
Distribution of HD signals through the matrix requires mutual communication or ‘handshake’ between source
and display. If there is any disparity between the two, successful transmission becomes problematic.
This matrix comes equipped with an EDID DIP switch on the rear panel for manual adjustment of matrix
settings to encourage communication between INPUT and OUTPUT devices. If installation compatibility issues
arise, check the settings on your
connected devices and adjust the DIP settings as required.
ATTENTION Changes to the DIP switch settings should be made with the matrix OFF, ideally with all power
cables and HDMI leads and UTP cables removed to guard against electrostatic build up that may damage your
system. DO NOT HOTSWAP your cables when changing DIP SETTINGS.
ALL changes to the DIP settings become effective upon powering ON the matrix.
EDID Copy from Output display to Input port (Force Signal Output mode)
To copy the EDID from an OUTPUT display to a specific INPUT port, first set the DIP switch to this position.
Then select the INPUT by pressing and holding the chosen OUTPUT SELECT button for 3 seconds for the EDID
to be copied from the DISPLAY to the INPUT port.
1080p 3D Video / Stereo Audio (using embedded M-series EDID)
FACTORY DEFAULT
Setting the DIP switch to this position will instruct the matrix to use embedded 1080p 3D video and Stereo
audio to encourage communication between the matrix and 3D sources/3D displays if handshake problems are
encountered.
After setting the DIP switch, reconnect and turn on for the changes to take effect.
RESETTING TO FACTORY DEFAULT:
As 1080p-3D-Stereo is the default factory setting for the matrix, to reset EDID of all ports,
simply set the DIP switch to the above position when the matrix is powered OFF. On powering
ON, all ports will revert to 1080p-3D-Stereo and DIP switches can be adjusted as necessary.
www.vanco1.com
888.769.4156 14