VANCO VPW-280759 - Manual (Page 19)

www.vanco1.com
888.769.4156 19
Click OK after assign the new IP and to return to the previous dialog. Click Search and Read Device. The
device can be displayed correctly.
ATTENTION: here assign IP is different from Set IP in COMCTL. Set IP in COMCTL is save the IP address in
flash, when the mx0808 power on, it will read the IP from flash and set it as static IP. Assign IP function used
when automatically obtain IP address failed. This assigned IP address is not saved in flash.
D.IR call-back from remote locations to control the 8x8 Matrix. You can use the Matrix’s remote through the
IR RX of the Receiver to change the input source for UTP output connected to this Receiver.
This function can be set on or off through Touch Panel.
E. Instruction of TX IR.
The sequence of "TX IR1,TX IR2,TX IR3,TX IR4,TX IR5,TX IR6,TX IR7,TX IR8" one-to-one correspond with
"HDMI INPUT1,HDMI INPUT2,HDMI INPUT3,HDMI INPUT4, HDMI INPUT5,HDMI INPUT6,HDMI INPUT7,HDMI
INPUT8". When an output chooses certain input, the call-back IR signal of RJ45 on this output port will choose
the corresponding "TX IR" port to send the signal out.
For example, OUTPUT1 chooses INPUT3,then the call-back IR signal of RJ45 on OUTPUT1 will choose "TX IR3"
to send the signal out.
Definition of IR Earphone Jack
Note: IR emitter should be affixed as near as possible to the DVD IR receive window.