VANCO VPW-280759 - Manual (Page 10)

www.vanco1.com
888.769.4156 10
NOTE: Red dot indicates that the corresponding RJ45 output port is in single output mode. Details please see the attached
CD-ROM about RJ45 output mode switch instructions.
Press “MS”- View the current status of matrix
Press “M1” - View the pre-existing state of matrix (Model 1)
Press “M2” - View the pre-existing state of matrix (Model 2)
Press “M3” - View the pre-existing state of matrix (Model 3)
Press “EQ” - View the current EQ setting status of matrix
NOTE: If the touch screen becomes insensitive, calibration is necessary.
Touch screen calibration method:Press the panel button “Setting” in the home menu status, holding until the following prompt
appears (about 4 sec).
Press the symbol’s center, until the one disappears and another symbol appears, and press its center again until the end of
the calibration—OK or Failure. If the calibration fails, please confirm whether the symbol’s center was aligned, then try again.
When finished with the calibration, press the panel button “Setting”, holding until exiting the calibration menu (about 4sec)
INFO MENU