ACP MOC24 Owner's Manual - Manual (Page 5)

5
Unpacking Oven
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours before
connecting power.
Radio Interference
Microwave operation may cause interference to radio, television, or a similar
oven. Reduce or eliminate interference by doing the following:
• Clean door and sealing surfaces of oven according to instructions in
Care and Cleaning section.
• Place radio, television, etc. as far as possible from oven.
• Use a properly installed antenna on radio, television, etc. to obtain
stronger signal reception.
Oven Placement
• Do not install oven next to or above source of heat, such as pizza
oven or deep fat fryer. This could cause microwave oven to operate
improperly and could shorten life of electrical parts.
• Do not block or obstruct oven louvers.
• Oven may be stacked.
• Install oven on level countertop surface or overshelf.
• If provided, place warning label in a conspicuous place close to
microwave oven.
• Outlet should be located so that plug is accessible when oven is in place.
For Enclosed Installation
A—Allow at least 7 “ (17.78 cm) of clearance around top. Proper air flow around oven
cools electrical components. With restricted air flow, oven may not operate
properly and life of electrical parts is reduced.
B—Allow at least 1” (2.54 cm) on sides of oven.
C—Allow at least 1 1/4” (3.18 cm) between air discharge on back of oven and back
wall.
Note: Back to back installation allows correct clearance.
Oven Clearances
Installation
To avoid risk of electrical shock or
death, this oven must be grounded.
The switching operation of this microwave oven can cause voltage
fluctuations on the supply line. The operation of this oven under unfavorable
voltage supply conditions can have adverse effects. This device is intended
for the connection to a power supply system with a maximum permissible
system impedance Zmax of 0.31 Ohm at the interface point of the user’s
supply. The user has to ensure that this device is connected only to a power
supply system which fulfills the requirement above. If necessary, the user
can ask the public power supply company for the system impedance at the
To avoid risk of electrical shock
or death, do not alter the plug.
Oven MUST be grounded.
Grounding reduces risk of electric
shock by providing an escape wire
for the electric current, if an electrical
short occurs. This oven is equipped
with a cord having a ground wire
with a grounding plug. The plug
must be plugged into an outlet that is
properly installed and grounded.
Consult a qualified electrician or
servicer if grounding instructions
are not completely understood, or if
doubt exists as to whether the oven
is properly grounded.
Do not use an extension cord.
If the product power cord is too
short, have a qualified electrician
install a three-slot receptacle.
This oven should be plugged
into a separate circuit with the
electrical rating as provided in
product specifications (available
on acpsolutions.com). When a
microwave oven is on a circuit with
other equipment, an increase in
cooking times may be required and
fuses can be blown.
External Equipotential
Earthing Terminal (export only)
Equipment has secondary earthing
terminal. Terminal provides external
earthing connection used in addition
to earthing prong on plug. Located
on outside of oven back, terminal is
marked with symbol shown below.
WARNING
WARNING
B
A
B
C
Grounding Instructions
Improper use of the grounding can
result in a risk of electric shock.
WARNING
(Export Only)