Care and cleaning, Splatter shield, Interior door – ACP MOC24 Owner's Manual User Manual
Page 11: Glide strips

11
Care and Cleaning
To avoid electrical shock which can cause severe personal injury
or death, unplug power cord or open circuit breaker to oven before
cleaning.
WARNING
Care and Cleaning
Clean interior and exterior of microwave oven with mild detergent and damp soft sponge or cloth. Wring cloth or
sponge to remove excess water before wiping equipment.
Splatter Shield
(Clean Monthly)
1. Unplug the oven.
2. Place fingers behind the shield, pull forward and then down. Do not bend antenna.
3. Clean soil from shield with damp cloth or clean with mild detergent and water.
Note: Do not run oven without splatter shield.
Interior Door
(Clean Daily)
1. To clean interior door, gently pull out on door
until door opens at a 90-degree angle.
2. Wipe the underside of door and inside door
arms with a damp cloth. Wipe dry.
Glide Strips
(Clean Monthly)
1. Unplug the oven.
2. Clean in between door arms and side of cavity with a cloth (
Do not use paper towels) on the end of a non metallic
spatula with mild detergent or degreaser, cleaning the glide strips on both sides of the cavity.
3. Clean end of each hinge bracket under the front of the door.
4. Place door back in ready position by gently pushing downward.
Important:
-Do not use abrasive cleaners or cleaners containing ammonia or citrus.
-Never pour water into microwave oven bottom.
-Do not use water pressure type cleaning systems.
Hinge Bracket
Hinge Bracket