ACP MRC17S2 Quick Start Guide - Manual

Manual Operation
To cook food using a specific entered time and power level.
1. Open oven door and place food in oven. Close door.
2. Press TIME ENTRY pad and enter cooking time.
3. Press POWER LEVEL pad to change power level if desired.
• For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%).
4. If stage cooking is desired, press STAGE pad and repeat steps 2 through 4.
5. Press START pad.
6. At end of cooking cycle oven beeps and shuts off.
DONE displays.
Programming Pads
1. READY must be in the display. If not, open and close door.
2. Press PROGRAM SAVE pad.
• Programming mode begins.
• Enter Program to Add/Review: displays.
3. Press pad to be programmed or reprogrammed.
• Display will change to review all settings for the pad.
• The pad number that is being programmed displays beside the word
ITEM.
4. Press TIME ENTRY to program amount of cooking time.
• Enter desired cooking time by using numeric key pads.
• Maximum cooking time is 60 minutes.
5. Press POWER LEVEL to program level of microwave power.
• Press numeric key pad for desired level. Press numeric key pad again
to set power level to 100%.
• For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%).
6. Press Quantity pad if different cooking factor is desired.
• Default of CF:80 displays.
• Enter desired cooking factor by using numeric key pads (1 for 10%
through 0 for 100%).
7. Press PROGRAM SAVE to save the program changes.
8. To discard changes, press STOP/RESET.
Mid-Cycle Pause
To add a pause to a programmed
cooking cycle:
1. Press HIDDEN PAD after
entering time or power level.
2. A short beep sounds. This
indicates the program is set for a
mid-cycle pause.
3. Continue programming pad as
desired.
When programmed pad is used,
pause will occur in the middle of total
programmed time. Oven will beep
continuously and Program Paused
displays until door is open and shut.
To continue cycle, press START pad.
CLEAN FILTER
This oven displays CLEAN FILTER
at user defined intervals. When the
message displays ACP recommends
cleaning the air filter thoroughly.
Cleaning the air filter will not shut
off the message. The message will
stop displaying automatically after
24 hours. Depending on microwave
use and environmental conditions,
the filter may need to be cleaned
more frequently. Once the frequency
is determined, set the option for the
appropriate time frame.
So...how do I use it?
Preprogrammed
Pads
To cook food using
preprogrammed cooking
sequences.
1. Open oven door and place food
in oven. Close door.
• To add additional servings
press QUANTITY pad.
• Up to eight quantities can be
added.
2. Press desired pad.
3. Oven begins to cook.
4. At end of cooking cycle oven
beeps and shuts off. DONE
displays.
Oven Clearances
A—For North American (UL/CSA) models, allow at
least 2” (5.1 cm) of clearance around top of oven.
For International (50 Hz) models, allow at least 7”
(17.8 cm) of clearance around top of oven. Proper air
flow around oven cools electrical components. With
restricted air flow, oven may not operate properly and
life of electrical parts is reduced.
B—Allow at least 2
9 /
16
” (6.5 cm) between air
discharge on back of oven and back wall.
C—Allow at least 2” (5.1 cm) around sides of oven.
Refer to Product Safety Manual for Safety Statements
Complete Owner’s Manual available online
Quick Start Reference Guide
Quantity Time Entry Power Level Stage Program Save