Velleman CAMIP13 Quick Installation Guide User Manual
Page 18
14
Detect
Item
Description
External Alarm
Set “N.O.” or “N.C.” depending on the configuration of your alarm-in device.
Motion
Enable (ON) or disable (OFF) motion detection.
Motion detection is not supported when the stream format is Motion JPEG.
When “Enable” is selected, click “Detection” to enter the motion detection area setting page as follows:
Level of Sensitivity:
Set the detection sensitivity from 1 ~ 10.
Area Setting:
Set the motion detection area by selecting the area grids with your mouse. Pink grids represent the area that is not being
detected while the transparent grids are the area under detection. You can set multiple areas under detection.
Click “Clear All” to set the whole area undetected.
Click “Select All” to set the whole area under detection.
Trigger Duration
Set the duration time for trigger recording (5 / 10 / 20 / 40 seconds).
Action
Here defines how the camera delivers alerts to you for any event.
Item
Description
Select the event type you want to receive E-mail notifications when it occurs.
Then, click the title “E-Mail” to configure the record time from 1 ~ 5 seconds.
The camera will send the captured video clip to the E-mail address(s) assigned in “Network” “Mail” once the selected
event type occurs.
FTP
Select the event type you want to receive FTP notifications when it occurs.
Then, click the title “FTP” to configure the record time from 1 ~ 5 seconds.
The camera will upload the captured video clip to the FTP site assigned in “Network” “Mail” once the selected event
type occurs.
Alarm Out
Select the event type you want to trigger the alarm-out device to work when it occurs.
Then, click the title “Alarm Out” to configure the trigger rule.