Uncle Milton Mars In My Room Light Up Planet - Manual (Page 2)

2176-0250-0413-V01
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2013 UMI. All rights reserved. ® and TM designate
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Do not dispose of batteries in fire. Battery may explode or leak.
Remote Control
1. Using a Phillips head screwdriver,
remove the battery cover
as shown.
2. Insert 2 "AAA"
batteries as
indicated in the
battery compart-
ment and replace
cover.
On/Off
button
Operation
IMPORTANT: The ON/OFF switch located on
the back of the Mars In My Room must be
switched to the ON position.
NOTE: For best Mars illumination, use in a darkened room.
On/Off
To turn the Mars on, press the ON/OFF button on your
remote. Press ON/OFF button again to turn off.
Auto Off
Mars automatically shuts off after approximately 30 minutes if
there is no manual interaction.
KEEP THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE —
DO NOT DISCARD
Questions?
Visit
unclemilton.com