Mounting to ceiling, Final assembly, Operation – Uncle Milton Fireflies In My Room User Manual
Page 2

Mounting to ceiling
Tool required - Drill, 7/16" drill bit, small screwdriver
NOTE: THIS STEP SHOULD BE DONE BY AN ADULT.
NOTE: PRODUCT IS ONLY INTENDED TO BE INSTALLED ON A HORIZONTAL DRYWALL CEILING.
BECAUSE OF VARIATIONS BETWEEN BUILDING MATERIALS AND CONSTRUCTION METHODS,
THE INCLUDED MOUNTING HARDWARE MAY NOT BE SUITABLE FOR ALL INSTALLATIONS.
1. Determine the hanging location, being aware of ceiling stud locations. IMPORTANT!
Make sure the mounting location is at least 20 inches from any walls or obstacles to
ensure necessary clearance for hanging leaves (fig. 3).
2. Using the mounting plate as a template, place the mounting plate against the ceiling with
the side marked "THIS SIDE DOWN" facing you. Using a pencil, mark the two outer holes.
3. With the markings you have made, drill two 7/16" holes all the way through the drywall.
4. Insert the hardware through the mounting plate as shown noting side labeled "THIS SIDE
DOWN."
5. Insert hardware through ceiling as shown (fig. 5).
6. Gently maintain a downward pull on the mounting plate while screwing the hardware
clockwise until the plate is snug against the ceiling. Do not over tighten (fig. 5).
7. Guide the three legs on the top of the Center Leaf into the corresponding holes on of the
mounting plate (fig. 6).
8. Rotate the Center Leaf clockwise until you feel it click into place (fig. 6).
Final assembly
1. Connect the remaining 5 Hanging Leaves by plugging the LED Cables into the back of
the leaves. Press firmly until you feel the Cable Connector snap into place (fig. 7).
2. Remove self adhesive backing and apply squares of foam tape to underside of fireflies
(fig. 8).
3. Locate the fireflies as desired onto the smooth surface of the leaves as shown making
sure the rear end of the firefly is fitting snugly against the LED. Press the each firmly into
place (fig. 8).
Operation
IMPORTANT: The On/Off switch located on the Center Leaf, must be switched to the
"ON" position.
1. Press the button on the Remote to turn on.
2. To turn off, press and hold the Remote button.
Note: To conserve battery life, the fireflies will turn off automatically after 30 minutes.
2162-0250-0412-V02
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit unclemilton.com
Mounting Plate
Mounting Plate
Ceiling
Ceiling
1"
Ceiling
Ceiling
Mounting Plate
MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2012 UMI. All rights reserved. ® and TM designate
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
20"
20"
Ceiling
fig. 3
fig. 4
fig. 5
fig. 6
fig. 7
fig. 8