Milton CAT PM 200 - Manual (Page 12)

12 PM-200 specifications
Service Refill Capacities
Liters Gallons
Fuel tank (useable) 1100 290
Engine oil w/filter 64 17
Propel planetary
gear reducer (each)
1.0 0.26
Hydraulic tank 200 52.8
Rotor clutch sump 48 12.7
Water spray system 3500 925
Hydraulic System
■ Pumps for propel, rotor drive,
collecting and upper conveyors,
auxiliary hydraulics and cooling fan
are installed on the engine mounting
pad.
■ Hydraulic oil cooler located at the
rear of the machine and arranged in a
modular stacked design for efficient
cooling and easy access for cleaning.
■ Three-micron filtration on pressure
side of auxiliary flow, seven-micron
filtration on return side. Machine
hydraulic circuit cleanliness level at
18/15 ISO code.
■ Quick-connect hydraulic test ports
simplify system diagnostics.
Water Spray System
■ Centrifugal pump supplies water to
spray nozzles for dust control and
belt lubrication.
■ Water spray nozzles focuses the
water spray in a flat fan pattern to the
rotor for better cooling of cutting
tools.
■ Nozzles are easily removed for
inspection and replacement without
the need for tools.
■ Standard system includes gauges to
monitor water pressure, low water
level indicators and water control
valves to conserve water usage.
■ An optional water spray system is
available for additional lubrication
and cutting tool cooling and for
additional dust abatement during
heavy-duty cutting applications.
■ Water tank can be filled from the top
of the machine or at ground level.
Frame
Fabricated from heavy gauge steel
plates and structural steel tubing. Track
assembly features track frame stops to
limit track angles to provide machine’s
ability to propel up inclines and out of
deep cuts. Top of deck and steps
features non-skid treads for sure
footing.
Grade and Slope Control
Machine elevation – rotor depth and cross slope controlled manually by operator is
standard. Automatic rotor depth and slope control is optional and features electronic
over hydraulic control. System can be configured with contacting or non-contacting
grade sensors. Slope sensor adds versatility.
Features
■ Machine elevation controls located on the operator’s console and at ground level
allows rotor depth and cross slope to be controlled manually. Visual depth gauge
displays depth of cut.
■ The optional AUTOMATIC grade and slope control automatically controls rotor
depth and cross slope to a preset cutting depth. Setting cutting depth is easily
accomplished first in manual mode by using the adjustment knob on the controller.
■ Remote mounted control boxes allow manual or automatic operation from either
the operator’s station or at ground level. A cross communication function allows
the operator to view and change settings of control boxes located on the opposite
side of the machine. This allows operators a means to control both sides of a job
from a single location. Constant read-out for rotor depth and cross slope are easily
visible in direct sunlight or low light conditions.
■ Sonic grade control sensors can be positioned on each side are easy to position
and provides a consistent accuracy.
■ Wire rope contacting grade sensor measures side plate movement that enables the
entire length of the side plate to become a mini averaging ski for optimum grade
matching.
■ Sonic Averaging System features three non-contacting grade sensors or a
combination of one contacting and two non-contacting sensors that mount on the
side of the machine. Enables the entire length of the machine to become an
averaging device.
■ Remote mounted control boxes and sonic grade sensors can be easily removed
and securely stowed to prevent damage or theft.