Milton CAT PM 201 - Manual (Page 12)

12 PM-201 specifications
Brakes
Primary Brake Features
■ Closed-loop hydrostatic drive
provides dynamic braking during
normal operation.
Parking Brake Features
■ Spring-applied/hydraulically-released
multiple disc type brake mounted on
each gear reducer. Secondary brakes
are activated by a button on the
operator’s console, loss of hydraulic
pressure in the brake circuit or when
the engine is shut down.
■ Propel pump is destroked when
parking brake is engaged. Propel
lever must be returned to neutral after
brake is released before machine will
propel.
Steering
Hydraulic power-assist steering with
two steering wheels on operator’s
console. Four steering modes with
automatic realignment of rear tracks
through ECM is standard.
Features
■ Double-acting steering cylinders
control the front and rear tracks and
are powered by a pressure-
compensated, piston-type pump.
Constant pressure is assured in the
steering system.
■ Switch on operator’s console
provides four steering modes.
Steering Modes
■ Front steer only—controlled by a
hand metering unit, maintained by
closed-loop control. The ECM
automatically aligns rear tracks to the
center position for straight tracking.
■ Rear steer—controlled by a toggle
switch on operator’s console,
maintained by closed-loop control.
■ Crab—front and rear tracks turn
simultaneously in the same direction.
■ Coordinated—front and rear tracks
turn simultaneously in the opposite
direction.
Turning Radius:
Minimum 4.66 m (15' 4")
Dimensions
Operating
A Overall length (conveyor up) 15.1 m 49' 5"
B Overall machine width 2.81 m 9' 2"
C Maximum height 5.04 m 16' 6"
D Minimum height 3.22 m 10' 7"
E Maximum truck clearance 4.75 m 15' 7"
Rotor ground clearance 305 mm 12"
Conveyor swing 45 degrees left or right of center
Collecting conveyor width 1020 mm 40"
Upper conveyor width 915 mm 36"
Inside turning radius 4.66 m 15' 4"
Shipping
F Length of base machine 8.25 m 27'
Length (conveyor down) 15.7 m 51' 6"
G Maximum height 2.98 m 9' 9"
H Maximum width 2.58 m 8' 5"
PM-201
Weights
Operating Weights*
Machine
35 110 kg 77,420 lb
on front tracks 19 310 kg 42,580 lb
on rear tracks 15 800 kg 34,840 lb
Weights shown are approximate and include coolant, lubricants, full fuel tank, full
water tank and a 75 kg (165 lb) operator.
Shipping Weights*
Machine
30 840 kg 68,000 lb
on front tracks 16 655 kg 36,720 lb
on rear tracks 14 185 kg 31,280 lb
Weights shown are approximate and include coolant, lubricants, 50% fuel level and
empty water tank.
*Weights do not include rotor. Include the appropriate rotor below to get the total weight required.
Rotor Configurations (add to above figures)
Conical
4055 kg 8942 lb
Breakaway 3035 kg 6687 lb
Weld-on 2945 kg 6488 lb
Rotor weights include cutting tools.
D G
H
F
A
C E
B