Altronix DP4 Installation Instructions - Manual

Overview:
DP4 Power Distributing Module conveniently converts a single AC/DC input into four invidually fused outputs.
Features:
• Converts a single AC or DC input into four individually fused outputs.
• Handles up to 48VAC/VDC
• Fuses rated at 3.5 amps (up to 5 amps fuses may be used)
• Power ON/OFF switch
• DIN Rail mount ready
Board dimensions:
3” L x 3.25” W x .75” H
Installation Instructions:
1. Mount DP4 in desired location.
2. Connect input power to terminals marked [(AC) + DC - (AC)].
3. Connect devices to be powered to
terminal pairs 1 to 4 marked [1A and
1B to 4A and 4B].
Note: For DC voltage applications terminals marked A are
Positive (+), and terminals marked B are Negative (-).
Note: It is important to measure polarity and
output voltage before connecting devices.
This helps avoid potential damage.
DP4 - Power Distribution Module
Input
power
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056
web site: www.altronix.com, e-mail: [email protected], Lifetime Warranty, Made in U.S.A.
IIDP4 - Rev. 111101
MEMBER