Altronix R615DC8ULCB Installation Instructions - Manual (Page 3)

R615DCUL Series - 3 -
The lightning flash with arrow head symbol within an equilateral triangle is intended to alert the user to the pres-
ence of an insulated DANGEROUS VOLTAGE within the product’s enclosure that may be of sufficient
magnitude to constitute an electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION: To reduce the risk of electric shock do not open enclosure. There are no
user serviceable parts inside. Refer servicing to qualified service personnel.
b. Tripped PTC (R615DC416ULCB, R615DC616ULCB & R615DC8ULCB) - To reset PTC, set power switch on the
back of the unit to the OFF position (Remove overloaded circuit condition prior to reset).
After approximately 30 secs. set power switch to the ON (RESET) position (Fig. 1e, pg. 3).
10. Power switch with built-in circuit breaker:
OFF position - Switch not Illuminated. Outputs not powered.
ON (RESET) position - Switch illuminated. Outputs powered.
Circuit breaker tripped - Switch not illuminated. Power LEDs on faceplate are not illuminated. Outputs not powered.
To reset circuit breaker set power switch to the ON (RESET) position (Fig. 1e, pg. 3).
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or moisture. For
continued protection against the risk of fire, replace the fuses only with same type and rating (3.5 amp @ 250V).
ALTRONIX CORP.
BROOKLYN, NY 11220
MADE IN USA
P
N
Trimpot
(Green Wire
Earth GND)
XFMR
+ AC -- + DC --
Power Supply
Board
ALTRONIX CORP.
BKLYN, NY 11220
MADE IN U.S.A.
Power
LED's
Power
LED's
Power
LED's
Power
LED's
PTC1
Used
on PTC
Models
Strain Relief
Line Cord
Trimpot
Power Switch
XFMR
Removable Terminal
Block
Fig. 1
Fig. 1c Fig. 1d Fig. 1e Fig. 1b
Fig. 1a