Altronix R248ULi Installation Instructions - Manual (Page 3)

R248/2416ULi series - 3 -
XFMR*
ALTRONIX CORP.
BROOKLYN, NY 11220 MADE IN USA
XFMR*
AC Power
LED's
AC Power
LED's
AC Power
LED's
AC Power
LED's
Removable Terminal
Block
Strain Relief
Line Cord
(Green Wire
Earth GND)
PTC1
Used
on PTC
Models
5A
250V
Illuminated
Power Disconnect
Circuit Breaker with
manual reset
Fig. 1 Fig. 1a Fig. 1b Fig. 1c
Fig. 1d
9. Power switch with built-in circuit breaker:
OFF position - Switch not illuminated. Outputs not powered.
RESET (ON) position - Switch illuminated. Outputs powered.
Circuit breaker tripped - Switch not illuminated. Power LEDs on faceplate are not illuminated. Outputs not powered.
To reset circuit breaker set power switch to the ON (RESET) position (Fig. 1c, pg. 3).
CAUTION: Equipment to be installed/serviced by authorized personnel only.
Shut brunch circuit power berfore servicing/installing equipment.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or
moisture. This installation should be made by qualified service personnel and should conform to
all local codes and in accordance with the National Electrical Code.
Fuse ratings:
Replace output fuses with the same type and rating 3.5A/250V.
Replace primary in-line fuse with the same type and rating 5A/250V.
The lightning flash with arrow head symbol within an equilateral triangle is intended to alert the user to the
presence of an insulated “DANGEROUS VOLTAGE” within the products enclosure that may be of sufficient
magnitude to constitute an electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION: To reduce the risk of electric shock do not open enclosure. There are
no user serviceable parts inside. Refer servicing to qualified service personnel.
3.5A 250V
Output Rating
5A 250V